Ramset 1524SDE Ramguard Pin with Washer, Steel, Zinc
Provides easier penetration into concrete, drywall and structural steel. 7/8 in washer prevents overdrive and increase holding value when fastening wood or thin metal to concrete or structural steel. Fits most powder actuated tools that use 22 cal. Single shots of 27 cal. Shank diameter of 0.145 in.
Buildex Tapcon 24292 Concrete Screw Anchor, 5/16 in Drive
Secure attachment to concrete, block and brick. One-piece design requires no assembly, does not require anchor torque-down, cracked and seismic approved. Blue ClimaSeal adds corrosion resistance. ANSI drill bit required.
CONCRETE ANCHOR TAPCON 5/16X3
Secure attachment to concrete, block and brick. One piece design requires no assembly, does not require anchor torque-down, cracked and seismic approved. Blue ClimaSeal adds corrosion resistance. ANSI drill bit required.
SCREW LATHE DRILL PT 12X1
Self-sealing neoprene washer for waterproof applications. Premium finish provides exceptional corrosion resistance in harsh outdoor environments. For metal-to-metal (26-22 gauge) or metal-to-wood applications. Applications: Attaching roofing and wall panels to steel framing, roofing panels over insulation to wood structure, pole barn construction.
Ramset C32CW Single Shot Powder Load, Green, 0.22 in Dia, 2-1/8 in L
ITW Ramset powder loads and tools match tolerances to provide optimum power within recognized national velocity standards. Power level is designated by the load level number marked on each box also by the color of the box and each powder load. As the number increases, the power level increases.
Ramset 1512 Drive Pin, Steel, Zinc
Use with Ramset, hilti, Remington and most powder actuated tools that use 22 cal single shots, 27 cal. 10 strips and 25 cal discs. For models of low velocity powder actuated tools with 300 or larger barrel diameter. Knurled shank pins for fastening to structural steel. Diameter of 0.145 in.
SCREW LATHE DRILL PT 8X1
No predrilling, screws tap their own threads, secure fastening and striping holding power. Allows for efficient material removal. Applications: Attaching metal lathe to steel studs for stucco/plaster applications, Attaching pre-drilled metal brackets to wood, Applications requiring a wide, low-profile head.
DRIVE PIN 1/2IN KNURLED 06171
Use with Ramset, Hilti, Remington and most powder actuated tools that use 22cal. single shots, 27cal. 10 strips and 25cal. discs. For models of low velocity powder actuated tools with.300 or larger barrel diameter. Knurled shank pins for fastening to structural steel; 0.145" diameter.